Programming system wide speed dial numbers on your Samsung phone system requires that you first log into programming as a system administrator.  To do this follow these instructions using any iDCS18d, iDCS28D, DS-5021D, DS-5014D or DS-5007 phone.

Leave your handset on hook and press Transfer 200
Enter 1234 Then press 1 again
You have now enabled programming, now press SPEAKER and dial 705
Dial 500 (this is the first speed dial bin)
Press 9 and then dial the phone number for this speed dial Bin.

After you have entered the phone number press the RIGHT Soft Key (This key is directly under the LCD display, there are three of them)

Now you may enter 501 for the next speed dial and follow the same steps above.  When you have finished with all your numbers press TRANSFER to exit programming.

To use these speed dials press the key on your phone marked Memory or SPD depending on the model of your telephone and then dial the bin number (example: memory 500)

To delete a speed dial entry on a Samsung OfficeServ phone system log in to the system.

Leave your handset on hook and press Transfer 200
Enter 1234 Then press 1 again

You have now enabled programming, now press SPEAKER and dial 705

Use the volume up to locate the speed dial bin number you wish to delete (500, 501, 502 , etc.)

When you have located the speed dial number you wish to delete press the third softkey under the display.

The cursor should move under the 9.

Press the HOLD key to delete the entry.

Press the third softkey again to move back under the speed dial bin numbers.

Press Transfer to log out.